Barudan Driver Replacement
On the X-Series machines we have here the #2 Head has an issue with the needle not going all the way down. As a troubleshooting procedure we turn the head on and engage the needle. This one in particular actually stayed locked in position until the timing wheel was turned closer to 300-0 degrees then the needle bar dropped out. Also we noticed that the presser foot did not go all the way into position. Which is about 5mm from the throat plate. So we also had to inspect and adjust the CAM which will be displayed at a later time.
This step-by-step guide will show you how to remove the head, replace the driver and adjust the needle depth. So follow along with me as we repair the needle bar assembly.
Quick fact: The number 1 reason that this problem occurs is that the operator will hit a hoop. Good Luck getting them to admit to it.